Fote spray dryer for drying materials can not be separated from the heat source, but because the materials to be dried types and properties of more complex, so the heat source and the heat transfer equipment has different requirements. Generally speaking, we are based on the material selection heat source.
When the rotary dryer cylinder displacement, simplified tire in riding wheel will appear on the side walk, rather than move parallel to the abnormal phenomenon, this phenomenon is due to the general tire and wheel wear results, so that the simplified installation tilt angle of rotary dryer is 5 degrees the balance degree of damage caused by. Therefore according to the simplified rotation direction, adjust appropriately simplified before and after any group of supporting wheel angle displacement, can be simplified to recover normal operation. Such as cylinder steering displacement, the fixing roller bolt is loosened, the roller to transform the angle, adjust the left roller, and the original horizontal line at 2 degrees, simplified will slowly move up, when simplified moved to a normal position, locking wheel bolt. Thus, when the cylinder rotates, the two axis parallel to the roller as tapered roller bearings, to generate an upward axial force in sand dryer. The raw material from the feeder machine of spray dryer go into the inner diameter and raw material raised up by lifting plate, the heat and raw material totally contact.then the raw material from the inner cylinder go into the middle cylinder and from the middle cylinder enter into the outer cylinder.Finally the dried material come out of the discharge of the sand drying machine.
Fote Machinery is located in a historical and cultural city, zhengzhou,which is a machinery industrial centre. Our factory is a skill-intensive and high-tech enterprise with technology development, which is also regarded as brilliant pearls of the domestic sand dryer machine.
sawdust dryer manufacturer: http://www.chinafote.com/pro/p99.html